Gate-driver IC for low-voltage brushless motor-control designs

December 08, 2020 // By Ally Winning
STMicroelectronics has launched an integrated three-phase half-bridge driver IC that has been optimized for low-voltage applications up to 75V.
STMicroelectronics has launched an integrated three-phase half-bridge driver IC that has been optimized for low-voltage applications up to 75V.

The STDRIVE101 is a small and low-power solution for the control of three-phase brushless motors. The IC integrates three half-bridge drivers for external N-Channel MOSFETs. Each driver is able to sink and source up to 600mA gate current. The device also integrates bootstrap diodes and a 50mA 12V LDO regulator for the power supply to external components. This level of integration reduces the BoM for designers and eases overall system design. A comparator is also integrated for over-current detection using external resistors and drain-source voltage monitoring of each MOSFET for short-circuit protection.

The device also has essential safety features built-in. These include internally generated dead-time to prevent cross-conduction, over-temperature shutdown, and Under-Voltage Lockout (UVLO) on both the low-side and high-side sections to prevent the MOSFETs from operating in low efficiency or dangerous conditions.

A DT/MODE selection pin gives designers the choice to control switching with individual high-side and low-side signals or a single PWM signal and enable input. A standby pin sets the STDRIVE101 in low-power mode with the LDO turned off to maximize energy savings when idle.

The STDRIVE101 is available now in a 24-pin VFQFN 4mm x 4mm package. It costs from $0.71 for orders of 1000 units.

More information

www.st.com/stdrive

Related news

Multi-OS software tool eases STM32 programming and protects IP

Multi-panel GUI configurator for the STM32 MCU

New high-performance STM32 value lines

New probe eases STM8 and STM32 programming


Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.